CANNA - pH+ | 1L - 5%
CANNA pH+ is an alkaline pH adjuster based on 5% caustic potash (KOH), used to raise the pH of nutrient solutions. It is designed for minor pH adjustments and is used after the fertiliser mixture has...
CANNA pH+ is an alkaline pH adjuster based on 5% caustic potash (KOH), used to raise the pH of nutrient solutions. It is designed for minor pH adjustments and is used after the fertiliser mixture has been prepared.
What is CANNA pH+ used for?
CANNA pH+ is an alkaline corrector for raising the pH of the nutrient solution. It is used during the growth and flowering stages, after the mixture has been prepared with water and fertilisers.
It should be measured against the complete solution, as the pH of the initial water may change after the nutrients have been added.
Technical data sheet
| pH-raising regulator | |
| Add a little at a time; quantity determined by measurement | |
| Preparation of the solution | |
| Measure before and after correction | |
| Compatibility with CANNA nutrient solutions |
Formulation and product selection
The same correction may require different quantities depending on the water’s hardness and buffering capacity: a dose used previously should be re-checked.
Instructions for use
Start with 5 ml per 100 L of solution, mix, measure and repeat only if necessary. The recommended range for this product is between 5.2 and 6.4.
The initial dosage does not replace the need for testing. Follow the precautions on the label.
Related products
- CANNA pH-Bloom — Lowers the pH of the nutrient solution to the desired level during the flowering stage.
- CANNA pH-Grow — An acid-based pH adjuster to regulate the pH of the nutrient solution during the vegetative phase.
CANNA: research and programmes for every growing medium
Since the early 1990s, CANNA has been developing fertilisers and growing media for growers using soil, coconut fibre or hydroponics. Its approach stems from a practical question: what changes when the growing medium changes? This has led to the creation of distinct product ranges, comprising basic nutrients and complementary products designed to be used in sequence. Research, trials and consultation with growers are integral to the company’s history, which aims to make the choice of programme – from the first nutrient to the additives – clearer.
CANNA states that it carries out research, laboratory testing and formulation development in-house. According to its presentation, the development of a new product takes on average around two years: a process that involves the design of specific product ranges for different growing media and cultivation systems.
-
4
Recalculation in progress …